?unique=8d7175d)
?unique=8d7175d)
ABH 0195 3/4" Offset Pivot Set x US32D - Stainless Steel
A 3/4" Offset pivot is defined as 3/4" from face of door to the centerline of the pivoting point. A key advantage of the jamb-mounted pivot set is that bottom pivot "rests" on the floor. This could allow for less notching in the field for flooring material.
The 0195 3/4" Offset Pivot is capable of handling doors with an undercut of up to 3/4" straight from the box. To achieve this maximum, the bottom arm must be surface mounted to the door's underside rather than being mortised. If you require additional spindle heights, please inquire for a quote. These extra heights may be necessary due to the addition of tile or marble flooring, or in situations involving ramps and sloped floors.
Pivot is supplied with a mix of half machine screws (1/4-20 x 3/4") intended for metal frames and half wood screws (#14 x 1-1/2") designed for wood doors. Please inform us if you require all wood screws or all machine screws.
For interior or exterior doors up to 4'0" x 8'0" weighing up to 450 lbs.
Bottom pivot mortised into side jamb
UL listed for use on 3-hour fire rated doors - Standard
3/16" vertical arm adjustment after installation
Heavy duty bearings
Stainless steel base material
BMHA/ANSI C07131/3530A (modified)
0180 Top Pivot included (see picture below)
*** ABH recommends that an 019 Intermediate pivot for doors above 60" tall should use one intermediate pivot in the center of the opening. An additional intermediate pivot should be used for each additional 30" in door height.
***
Special Note: The door handing information in needed upon order placement. If you are unsure of the handing of your door, please compare the picture below to your opening for clarification.
| Door Hand | LH - Left Hand or RH - Right Hand or RHR - Right Hand Reverse or LHR - Left Hand Reverse |
| Brand | ABH Mfg |
| Pivot Type | Offset Pivot |
| General - US Finishes | US32D - Satin Stainless Steel/ 630 |
| Base Material | Stainless Steel |